fbpx

Maintenance

Ensure the proper functioning of your HEAD PRESSURIZERS products by following these simple cleaning and maintenance guidelines

The dirt or sand particles present on tennis and padel courts, as well as ball balls, may adhere to the joint or toric joint of the pressurisers and make it difficult to seal the air inside the pressuriser. For this reason, it is essentiel de nettoyer et de lubrifier régulièrement les produits.

To lubricate the products HEAD PRESSURIZERSWhatever the model, you should disassemble the torque joint with a non-cutting tool and clean it with a scraper. You should also clean the cavity where the torque joint is located, as well as the spiral of the lock and the inside of the cover.

Ensuite, il faut lubrifier sans excès the locking spiral and the torque joint with the silicone rubber. If silicone rubber is not available, water-based vaseline or liquid glycerine may also be used. It is advisable to carry out this operation two or three times a year, depending on the use made of the HEAD PRESSURIZERS.

Nettoyage HEAD X3 and HEAD X4

 

NETTOYER LE PRESSURISEUR DE FOIS ET LE LUBRIFIER :

  1. Remove the torque joint with a non-cutting object to avoid damaging it and clean it with a paper mortise.
  2. Clean the cavity or the hole where the torque joint and the spiral are placed with a paper mould.
  3. Wipe the inside of the cover with a paper sleeve.
  4. Lubricate PAS EN EXCÈS with silicone grease. We recommend the WEICON brand.

Nettoyage HEAD X100 BASKET

 

CLEAN AND LUBRICATE THE PRESSURISATION SET ONCE AND LUBRICATE IT:

  1. Remove the coupling and the torque joint with a non-marring object to avoid damage and clean it with a paper knife.
  2. Clean the cavity or the hole in the cover where the torque joint is placed with a paper moulding.
  3. Clean the contour of the base where the torque joint rests with a paper moulding.
  4. Lubricate the PAS EN EXCÈS torque joint with silicone grease or neutral vaseline. We recommend the WEICON brand.